The prototype should be made as clean on the surface and detailed as possible, that it reflect the designs and idea 100%.
When we have a design in front of use, we know what problems occur during the production cycle and on which part the product is vulnerable for porosity, cracks, marks and holes and difficult to clean.
For this reason, we view (study) the design, before we going to produce the prototype and decide with the gold-smith in how many part we split it up.

We produce the prototype in as many pieces that are allow easy casting, cleaning and assembly and have the best possible finish product.
On the part to be assembled, we fix small pin in order to affix the parts exact correct every time

 

 
Some products like bracelets, pendants, earring, and necklaces have movement’s parts.
This part should be as flexible and fine as possible with the required strength.

These assembly techniques (solution), we use for this moving part, have advantages:
 
  • Easy to assembly
  • Don’t live visible solder points after polishing
 


This solution doesn’t increase the price for production; it saves time for filling and re-pairs

You will benefit from our production experience.



 


CONTACT ADDRESS : 161/41 CHAROENWIANG ROAD, BANGRAK  BANGKOK  10500  THAILAND.
PHONE : 662-237-6815 FAX : 662-353-1151

COPYRIGHT ©  2 0 0 0 - 2 0 1 6   D4U WEB TM ALL RIGHTS RESERVED
PATENTED  |  COPYRIGHT ACT INFO  |  TRADEMARK INFO  |  PRIVACY POLICY  |  TERMS OF USE

Web Counter

TM TM TM TM TM
TM TM TM TM TM TM
TM TM TM TM